The Ultimate Guide To h4831 vs h4831sc

The Ultimate Guide To h4831 vs h4831sc

Blog Article

I gave up on it and went to other powder once the new powder was building much more strain and was slower compared to old things. I don't keep in mind if I even experimented with normal h4831 or not; I am wondering not.

I'd say you'd be superior off seeing if a person might be ready to trade you some Varget in your H4831SC.

The reality that the H4831 is in truth a slower burning powder is precisely why you might be viewing greater velocities attained with that powder, rather than Whatever you've viewed While using the IMR things. Also good powder, but somewhat much better suited to marginally smaller scenarios by using a little bit a lot less ability.

Sweet!! I'll decide some up and give it a try out. Thanks guys, I take pleasure in it! I'll Enable you to understand what I uncover. I do have about a 50 % pound of 4350 I'm able to attempt that initially and see what takes place.

some cartridges tend copper foul much more than Other people however, in spite of how clean the finish is to the bore and require cleaning with the copper fouling more typically.

Did you at any time consider H4831sc in you 300wsm and 215 bergers. I've a 300wsm now. Capturing 180g with H4350 at 2940fps with normal chamber. Asking yourself what to expect with 215 bergers with H4331sc?

Anyone loading 7mm Rem Mag with H4831sc? How are the results, any data you'll be able to share? Must also point out I've some ELD-X 175's I h4831sc want to test out, When you have facts on that also.

Anyhow, I wanted to give some 7828SC a attempt to lower a number of the compression. What a error, I couldn't get this powder to shoot precisely or deliver the velocities I get with common 7828.

The primary reason I switched from IMR 4831 to H4831 was to benefit from the temperature insensitivity of the Hodgdon Serious powder.

You could have to help make a handful of more posts to obtain cleared to complete PM's. After you get to that status I might write-up during the categorised reloading part to discover if everyone is in your area for any trade. Click to expand...

I have experienced comparable encounter with H4350. For me, some ball powders would not shoot nicely with everything apart from Fed215's. Some components just Never Enjoy well with other. Looks like you have preferred three good powders, I'd assume no less than one of these to shoot.

This really is an Excessive extruded propellant and features heightened insensitivity to hot and cold temperatures.

arkansas or ohio i under no circumstances h4831sc observed a change aside from the regular is like rolling cordwood onto the the pan.

I found that my 7mag a hundred and sixty partitions have been sub MOA with 4831sc with minimal to min costs. I’m conversing h4831 vs h4831sc 2700 (probably 2800) fps, it had been a reduced 60s grain demand in the Norma situation. Not what I had been in search of, but correct nonetheless.